How do you guys set up your Sharps carbine sights?

[Maillemaker]

So I set up my Pedersoli Sharps Carbine so that with the ladder folded down, the rear sight and my front sight blade (I replaced it with a taller one) shoots the bullseye with a 6 o'clock hold on the bullseye at 50 yards.

https://i.imgur.com/hdFCvigl.jpg
https://i.imgur.com/AeekiHOl.jpg

But I cannot find a good solution for a 100 yard sight picture.

If I flip up the ladder, and use the lower-most notch in the ladder frame, that is too low. It's basically the 50 yard sight picture I think.

If I flip up the ladder, and slide the slider all the way down to the bottom, that is too high.
https://i.imgur.com/Bu04gfll.jpg

So I'm thinking I need to fill in the bottom of the hollowed out spot of the ladder to get a good 100 yard sight platform?

What do you guys do?

Steve

[P.Altland]

FWIW, I soldered a piece of flat metal into the center of the ladder and filed a notch. I shoot with the slider held all the way to the top of the ladder to keep it out of the way.


Sent from my iPhone using Tapatalk

[Wayne Clark]

Steve,
Sent you a PM.
W. Clark

[Maillemaker]

FWIW, I soldered a piece of flat metal into the center of the ladder and filed a notch. I shoot with the slider held all the way to the top of the ladder to keep it out of the way.

Thanks, Paul, that's what I had in mind, too.

Another suggestion was to use the slider to construct a square "peep hole" between the bottom of the ladder opening and the bottom of the slider.

I like a more "definite" site so I may go the solder route.

Steve

[P.Altland]

Thanks, Paul, that's what I had in mind, too.

Another suggestion was to use the slider to construct a square "peep hole" between the bottom of the ladder opening and the bottom of the slider.

I like a more "definite" site so I may go the solder route.

Steve

Not sure that I follow. Is the suggestion to flip the slider upside down so that the two V-notches create a peep? [emoji848]


Sent from my iPhone using Tapatalk

[Randall]

I ran across a thread that said that this member was making peep sights that didn't need any alterations. Kevin 847-650-1209

[Randall]

The person is Kevin Herrick from the 46th Il. if he is still making them or not I don't know.

[Maillemaker]

Not sure that I follow. Is the suggestion to flip the slider upside down so that the two V-notches create a peep?

No, I think what they are suggesting is to lower the slider all the way to the bottom, then push it up one or two notches, which opens up a little window under the slider that you can use as kind of a "ghost ring" peep sight.

Steve

[P.Altland]

Oh!


Sent from my iPhone using Tapatalk

[K. Herrick]

Steve,

A PM was sent to you.

Thanks, Kevin