Activity Stream

Thanks Bob, We will take him. Please PM me with contact info.

Done, will shoot you a pm

If you are still available for carbine I could use you Bob Gorsky, 8th VA

Stefan I have a henry shooter for you at Nationals Bob

Email sent to your email address

Jim Buckwell, those measurements seem a little strange . Are you saying a .509 bore and .528 grove diameters? Also the 1 in 28? twist seems to be...

I?m not 100% certain, but I believe the first one came out recently in The Muzzle Blast . The second was just accepted. I?ll find out for sure the...

Well if you do,,, make me a couple Minies so I can try it to... HA! I ordered a round ball and the 44... DPB

I saw two... the Grain Semi Wad Cutter and the .457 Round Ball. Thanks for looking out for us. DPB f 5 stars

Mgmradio - Where will the series of articles be available?

Big Mike - there is an original Gallagher bullet for sale on Ebay right now with a bit of case still attached for 12.99 buy it now. You may want to...

Hal, The breach blocks between the slanting breach and the new model are different. The new model uses the Conant plate in the breach block to...

I pushed a bullet through the bore of my gun and confirmed it has 6 lands and grooves, the major diameter is .528" and the minimum diameter is .509"....

I'm certainly no expert, but I have read that the slant breech models did not seal as well as the later 59 and 63 models. My wife shoots an original...

Mgmradio? that should be an interesting video when it comes out. I suspect the sharps in the YouTube video must have been too worn to keep the breech...

Bump to top

I?m planing on shooting the Spencer match if you are looking for someone. thanks

PM sent on rifle.

Are you still looking for a Spencer shooter? If so I?m available.

I stil have a few hundred pounds available. Not sure if I?ll get more in and made into ingots before the nationals. Place your orders now before...

I still have plenty of sheet lead available. See above for the details. Thanks