FOUND! Thanks. Looking for the knob that fits hand ejector on Merwin Bray 1861 Ballard Carbine.
Thnaks
FOUND! Thanks. Looking for the knob that fits hand ejector on Merwin Bray 1861 Ballard Carbine.
Thnaks
Last edited by Waldensridge; 01-24-2021 at 05:50 AM. Reason: Located part
Phil Siess at S&S will have the knobs by this Friday. He had some made up, both threaded and unthreaded. I believe(?) the originals are threaded at 12-40 but many of the extractors have different thread sizes. I have a collection of extractor "devices" that I have removed from Ballards. The unthreaded knobs will allow you to fit the knob to your extractor. S&S tel. no. 718-497-1100
Jack Conway
69th NY
Thank you Jack, I will give him a call.
S&S has these available as Jack stated in earlier post if anyone else is in need. Thanks Jack for the recommendation.
I'm glad S&S was able to help you out. He also has some of the Rifle Shoppe parts available.
This is a picture of various Ballard extractor knobs that I have replaced over the years.
Jack Conway
69th NY
Bookmarks