Any one out there in skirmish land can get me the dimensions of this carbine? I would like to take a try at building this arm. Had one fellow who has one but was afraid of FAKING it this is not my intent! I build rare Confederate rifles and carbines as muzzle loaders but would like to give this one a shot. Think it will be a big undertaking But aint skeered! The dimensions and pics will be a big help, want it as accurate as possible, have taken lots of pics from the internet and have a good idea of what it will take to do this. Have a mill and lathe at my finger tips and plenty of knowledge on the operation and lots of good sharp files. Any help would be greatly appreciated. Thanks to all who help. R Filbert 7519V Hazelwood Vol.