Moulds for sale

[John Bly]

I have the following moulds for sale. They have all been checked for alignment and I made sure they close properly. They were deburred where needed and the pins adjusted if needed. I have not made any bullets with these so I can't tell you what size bullet they will make. They are ready to use to make bullets. Add $6 shipping with each mould. Buy 2 or more and save on shipping. I can deliver to Ft. Shenandoah at any skirmish up to and including fall Nat'l.

(1) Lyman 575213 New style 515 gr., very good original condition, base plug fits properly. $45 -SOLD Pending Funds

(1) Lyman 575213 Old Style 460 gr., Has a small amount of wire brush damage on one edge, otherwise good shape. I think it will still make a good bullet. Base pin fits properly $35

(1) Ideal 575494 315 gr wadcutter, good condition, base pin fits properly. It is the old style base pin with a pin instead of the "C" ring. $45 SOLD pending funds

(1) Lyman 557489 ringtail Sharps bullet, good condition, should make a good bullet $60 SOLD pending funds

(1) Parker Hale Enfield 58560, like new condition with original box and instructions $75 SOLD pending funds

PM me for any additional information. I have pictures of each mould also. Thanks for looking.

[Muley Gil]

I'll take # 1, the new style Minie 575213. PM me with your address. Do you want a check or MO?

[John Bly]

PM sent to Muley Gil

[Hellgate]

I'll take the 575494. Lemme know where to send the $51. Will send a PM.
Tye in Orygun

[John Bly]

PM sent to Hellgate.

[Richard Hill]

I'd like the Lyman 557489. Still got it?

[John Bly]

Yes, it's still here. I just sent you a PM with where to send the payment. Thanks for your business, John