casewhite41
01-11-2009, 01:46 PM
I have a Pedersoli Confederate / Robinson Sharps purchased new from Dixie Gun Works in October 2008. It has a fixed sleeve with the chromed gas check plate and 2 of the “wave’ spring washers between the plate and the block.
Using 50 grains of loose powder, I was able to fire the gun 7 times before the action froze up. I spoke with Charlie Hahn and might try his short sleeve and O-ring modification. I also like Southron Sr’s o-ring mod behind the gas check plate since it’s simpler and less expensive.
A friend of mine has an original 1863 Sharps percussion carbine which he shoots with little or no problem with regard to the action freezing up. We compared the 2 designs for the gas check plate and found few similarities. The original Sharps check plate has a wide-mouthed inverted cone protruding from the back of the plate which captures and redirects the gas back against the plate forcing the plate to move forward against the sleeve. This may be imperfect but it seems to work pretty on his original Sharps.
My Pedersoli on the other hand has a flat surfaced, straight cut protrusion on the back of the check plate with a small flash-hole cut through the center of it. The way the plate is designed it will not capture any of the escaping gas and it depends only on the pressure of the wave springs (useless) or o-rings to force the plate forward against the sleeve.
I’m sure this isn’t news to long time members of this board who are familiar with the Sharps; but, as a newcomer I was surprised to see such a patent disregard of Sharps’ original concept.
Have any of the reproductions ever used Christian Sharps’ original design for the cone on the back of the gas check plate? Why was this design abandoned – expense of manufacture?
Can anyone recommend a proven “fix” for the gas leakage problem and some of the better gunsmiths who are good at fixing this problem?
Thanks, Casewhite
Using 50 grains of loose powder, I was able to fire the gun 7 times before the action froze up. I spoke with Charlie Hahn and might try his short sleeve and O-ring modification. I also like Southron Sr’s o-ring mod behind the gas check plate since it’s simpler and less expensive.
A friend of mine has an original 1863 Sharps percussion carbine which he shoots with little or no problem with regard to the action freezing up. We compared the 2 designs for the gas check plate and found few similarities. The original Sharps check plate has a wide-mouthed inverted cone protruding from the back of the plate which captures and redirects the gas back against the plate forcing the plate to move forward against the sleeve. This may be imperfect but it seems to work pretty on his original Sharps.
My Pedersoli on the other hand has a flat surfaced, straight cut protrusion on the back of the check plate with a small flash-hole cut through the center of it. The way the plate is designed it will not capture any of the escaping gas and it depends only on the pressure of the wave springs (useless) or o-rings to force the plate forward against the sleeve.
I’m sure this isn’t news to long time members of this board who are familiar with the Sharps; but, as a newcomer I was surprised to see such a patent disregard of Sharps’ original concept.
Have any of the reproductions ever used Christian Sharps’ original design for the cone on the back of the gas check plate? Why was this design abandoned – expense of manufacture?
Can anyone recommend a proven “fix” for the gas leakage problem and some of the better gunsmiths who are good at fixing this problem?
Thanks, Casewhite