wolf57
05-21-2008, 09:01 AM
Has anyone out there been successful in correcting the timing in a revolver. I looked down the barrel with a light and see that the chambers are a bit moved counter clockwise. All chambers are out the same amount at full cock. Everything is smooth and locks up nicely. It seems the cyl. stop is a bit loose as I can rotate the cyl. slightly at full cock and almost get a perfect alignment. It is not all that much and the forcing cone will make some correction but it would be nice to get it right.
Suggestions....
Bert, 1st. Reg. Eng.
Suggestions....
Bert, 1st. Reg. Eng.