Mould Sizing

[shilohzowie]

I have a mould which I am fond of,but would like to have it reamed(?) approximately 2-3 thousandths over. Is this possible? If so,who ,where,and any other info would be appreciated. If the mould is able to be oversized,should the base plug be oversized also? Can't buy a new mould of the size wanted as this is somewhat custom. Thanks.

[Joe Burchette, 2440V]

yes it is possable to do it on a lathe or a mill. but, I had three molds ruined about 25 years ago by someone who was supposed to be able to do it.

[Charlie Hahn]

I would be willing to take a look at it. I have a set of laps I use to remove this small amount, and have done several. I need to know the mould material, (steel, iron, brass, or aluminum) and the size and style.

Chalrie Hahn
410-208-4736

[Phil Spaugy, 3475V]

charlie does great work in a timely manner. You will be very satisfied.

Phil

[shilohzowie]

- P.M. sent sir.