View Full Version : .575 sizer
Dan Mastin
02-21-2015, 10:34 AM
I need a .575 push through sizer for a Rapine press. Anyone have one to sell or know who might be making them now that Ray is retired?
Dan M
Fred Jr
02-21-2015, 02:18 PM
Hi Dan,
I have a couple 575 dies but I am not sure what you need for a Rapine sizer. These are just straight dies.
Fred
Dan Mastin
02-21-2015, 02:45 PM
Fred
The sizer I need would have straight sides and have an outside diameter of 7/8 of an inch. If this is what you have....how much.
Thanks for the reply
Dan
Fred Jr
02-21-2015, 06:18 PM
Sorry Dan, it's 1inch dia.
Dan Mastin
02-21-2015, 08:26 PM
Fred
Thanks for checking.
Dan
brimorse
02-22-2015, 07:33 AM
Fred,
Is one of your 575 dies a push through type- like you would put in a vice? I could use one...
Bri
Hi Dan,
I have a couple 575 dies but I am not sure what you need for a Rapine sizer. These are just straight dies.
Fred
Fred Jr
02-22-2015, 08:17 AM
Good morning, It is a straight sided cylinder. I don't know if you could hold it in a vice.
Fred
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.